Reducer is a common power transmission mechanism, in all types of mechanical transmission systems are used

small bevel gearbox is a common power transmission mechanism, in all kinds of mechanical transmission systems are used. Reducer of the device and the use of direct operation related to the reducer results, to fit the skills standards and norms. Reducer reasonable device and use, pay attention to the following points.
1, the hollow shaft gearmotor in the device, we must pay special attention to the middle of the transmission center of the alignment, the error can not be exceeded by the reducer used in the amount of compensation for the coupling. Reducer in accordance with the requirements of the center, you can get more fantastic transmission results and more durable life.
2, the output shaft of the reducer on the device transmission parts, we must pay attention to the operation of the soft, to stop the use of hammer and other things rough device, it is best to use the assembly fixture and the end of the internal thread of the device, Drive parts into the reducer, so that maintenance of internal parts of the reducer will not be damaged.
3, reducer used in a variety of optional coupling type, but it is best not to use a steel fixed coupling, the coupling device is more difficult, once the device will increase the load will be defective , Easy to form the bearing damage, and even the formation of the output shaft fracture.
4, miniature bevel gearbox fixed is very important, to ensure that the smooth and strong, in general, we should reducer installed in a degree of foundation or base, but also the oil tank oil tank should be able to remove, and cooling air cycle fluent. Reducer fixed is not good, the foundation is not reliable, it will show the formation of vibration and other scenes, will make the bearings and gears have been unnecessary damage.
5, the reducer transmission coupling should be installed when necessary protective installation, such as the connector with a protrusion or the use of gears, sprocket drive, etc., if the output shaft to accept the radial load is large, it should be used to enhance type.
6, reducer position to ensure the operation of the staff, including easy access to the cursor, ventilation plug and drain plug and other status. After the completion of the reducer, the consoles should be in accordance with the specific order to reflect the accuracy of the status of the device to determine the integrity of the fasteners and so on.
7, before the operation of the reducer, but also to do the preparatory work, the oil pool of the vent hole plug removed into the ventilation plug, open the oil plug plug screw to reflect the oil line height, add smooth oil beyond the oil level plug Hole overflow, and then screw on the oil plug and be sure, you can start trial run.
8, reducer test run time can not be less than two hours, the normal operation of the specification is smooth, no vibration, no noise, no leakage, no impact, if the abnormal situation should be cleaned in real time.